I have a 2002 Mecury Moutaineer that has the left rear brake caliper sticking on sometimes. I think caliper piston is sticking. I bought one new one and was going to replace the brake pads while I am at it, but is it possible to bleed just that one brake caliper with out upsetting the ...

I’ve got a clicking sound when I press on the brakes. Repair shop says I need to replace a caliper. They say that the pads are still at 70% but they say that in addition to replacing the calipers, they need to replace the rotors and pads. I think that’s baloney. Why do the other ...

I have a 2006 Honda Accord SE with 70,000 miles that I take very good care of. Last night I was driving home and heard a horrible grinding sound coming from the rear right area. I took the car to Honda thinking all i needed was rear brake pads. According to them, I need a ...

If it’s a rear disc brake then there’s a good chance you’ll need a spanner tool to screw the piston back into the caliper. It cost me like $12 bucks at o’reilly’s. You just put it on a 3/8″ drive ratchet with about a 6″ extention. ...

i have replaced brake pads on the rear but the front set-up is different. there are 2 giant hex nuts and two bolts. the hex seems to be for the caliper while the bolts for the caliper bracket. which do i remove? i don’t see the usual long bolts on the caliper. there are sensors ...

So, I need a new driver side front brake caliper…I went to a junk yard and found a caliper in good condition, but it is off a mazda 626. I know the 626’s calipers are the same from like 94-03. My mazda 6 is an ‘04. I checked it out and it looks the exact ...

Remove the calipers, then remove the worn pads. Using a pair of larger sized channel locks has always worked for me to compress the piston(s). Then properly lube and grease the back side of your new pads and set them in the caliper and reinstall the caliper. ...

The Nissan Sunny is one of the easier brake pads to replace.Jack up and remove front road wheel.Put under car for safety.The brake caliper bolt at the bottom is removed with a 12or 13mm spanner.The caliper should then swivel up on the topbolt to allow the brake pads to be removed.Once this is done swivel ...

this is the answer i got to a previous question about speed dropping and that the car would die even after being jumped though it has a new-ish battery: “[After a] long period of not using the vehicle,cause some problem to the moving parts that became rusty.Feel the wheel hub after a long drive.If its too ...

Several potential issues. First two posters had good suggestions. It could be the caliper slides, it could be the caliper itself, could be a bad brake line and it could also be just some crappy fluid. A brake fluid flush could solve the line problem and/or the caliper problem, however if they ...