Saturday, September 19th, 2009
Ok, I have a 1999 bmw 323i e46. I want to swap the trans. out to a manual one. I know everyone says just trade it in for the same car with the manual trans. I can’t do that due to the fact that i’ve already put over 4k into payments and have around 11k ...
Posted in BMW | 4 Comments »
Tuesday, September 1st, 2009
Does this sound like valvetrain noise? Possibly collapsed hydraulic lifters or piston slap??? The engine has 140,000km on it, with the only major mechanical work done to it being timing belt, tensioner and water pump about 5000km ago. The noise became noticeable after a few oil changes, perhaps some debris came loose ...
Posted in Volkswagen | 2 Comments »
Sunday, October 4th, 2009
Does your 2.0L engine have a ” LIFTING RING ” mounted anywhere on the rear of the block (trans. end) if so, where ? Clutch (and maybe the trans.) are history.. Don’t have a lift so dropping the eng./ trans is out of the question.. Can get (or build ) an engine crane but have ...
Posted in Honda | 2 Comments »
Friday, February 12th, 2010
Does your 2.0L engine have a ” LIFTING RING ” mounted anywhere on the rear of the block (trans. end) if so, where ? Clutch (and maybe the trans.) are history.. Don’t have a lift so dropping the eng./ trans is out of the question.. Can get (or build ) an engine crane but have ...
Posted in Honda | 2 Comments »
Thursday, July 9th, 2009
I have a 99 Jeep Grand Cherokee limited 4×4. It now has 240,000 miles on it. The body is in almost perfect condition. I am looking for suggestions on where to buy parts for the engine rebuild (4.7 v8) or a rebuild kit that includes everything. Just curious on how many would suggest ...
Posted in Audi | 5 Comments »
Tuesday, October 6th, 2009
Im looking to buy and rebuild a full Harley Davidson Motorcyle. I need a bike with good gas mileage that I can improve with the rebuilding, something smaller in weight and height, and theres no age limit.
Any suggestions on cheap-to-build Harleys and a quote on how much it’ll cost to rebuild?
...
Posted in Motorcycles | 2 Comments »
Friday, September 18th, 2009
The automatic trans uses a clutch pack and piston and it is controlled by the computer electronically.There is a small solenoid and valve body in the tail housing of the trans and the computer can vary the amount of engagement of the AWD.
The standard trans uses a viscous ...
Posted in Subaru | 6 Comments »
Tuesday, August 18th, 2009
Your local bone yard. I’ve $aved much by going to the local Ecology Auto Wreckers. Make sure the carb is all there, has no cracks, then go to your local Auto Zone and get a bucket of Gunk carb cleaner, a rebuild kit, including floats, and a rebuild manual. You may need ...
Posted in Ford | 1 Comment »
Monday, September 28th, 2009
I have replace it 3 times and it keeps going bad is this a common problem with these transmission and is it a good idea to rebuild.
...
Posted in Mitsubishi | 6 Comments »
Thursday, September 24th, 2009
I have a Jeep Grand Cherokee bought in July of 1993. It has a In-line 6 engine. The connector at the top of the valve cover that I am showing in the included video I assume is part of the PCV system. The connector looks like a rubber tube has been torn ...
Posted in Jeep | 1 Comment »